WM2496H*M Page 44 of 58 TRAINING MANUAL
DISASSEMBLY/REPAIR (Heater)
1. Remove the front cabinet.
(See page 40.)
2. Drain the water from the sump.
(See page 40.)
3. Remove the push-on
connectors from the heater.
There may be a hidden
release on the terminals.
4. Remove the nut that holds the
ground wire. Then loosen but
do not remove the nut that
secures the heater clamp and
pull the heater out. You may
have to wiggle it to release the
gasket.
Be sure to pull the heater
element STRAIGHT out
to avoid damaging it.
DISASSEMBLY/REPAIR (Thermistor)
1. Remove the front cabinet.
(See page 40.)
2. Drain the water from the sump.
(See page 40.)
3. Unplug the white connector.
4. Hold the bracket and pull the
thermistor out.
To Next Page
Loading...
