USNGSMARTDIAGNOSIS_' 37
USING SMARTDIAGNOSIS TM
" Only use this feature when instructed to do so by the call center. The transmission sounds similar to a fax machine, and so has no meaning
except to the call center.
, SmartDiagnosis TM cannot be activated if the washer does not power up. If this happens, then troubleshooting must be done without
SmartDiagnosis TM.
If you experience problems with your washer, call %800-243-0000 (1-888-542-2623 in Canada). Follow the call center agent's
instructions, and perform the following steps when requested:
1. Press the xL_z button to turn on the washer. Do not press any other buttons or turn the cycle selector knob.
2. When instructed to do so by the call center_ place the mouthpiece of your phone very close to the POWER button.
iiliilTM
3. Press and hold the _[T_) button for three seconds, while holding the phone mouthpiece to the icon or POWER button.
4. Keep the phone in place until the tone transmission has finished.
This takes about 6 seconds, and the display will count down the time.
. For best result% do not move the phone while the tones are being transmitted.
, If the call center agent is not able to get an accurate recording of the data, you may be asked to try again
" Pressing the POWER button during the transmission will shut off the SmartDiagnosis TM.
5. Once the countdown is over and the tones have stopped, resume your conversation with the call center agent, who will then be able to assist
you using the information transmitted for analysis at the call center.
To Next Page
Loading...
