÷ Beforecleaningthewasherinterior,unplugthe electricalpowercordto avoidelectricalshock
hazards.
÷ Whendisposingof theappliance,cutoff themainscable,destroythe plug,and disablethe door
lockto preventyoungchildrenbeingtrappedinside.
• The water inlet filter
-" IE "error message will blink on the control panel when water does not enter the
detergent drawer.
- If your water is very hard or contains traces of lime deposit, the water inletfilter may
become clogged. We recommend cleaning it every few months.
1. Turn off the
water tap.
3. Clean the
filter using a
hard bristle
brush.
• The drain pump filter
÷ Thedrain filter collectsthreads and small objects left in the laundry.
Check regularly that the filter is clean to ensure smooth running ofyour machine.
2. Unscrew the
water inlet
hose.
4. Tighten the
inlet hose.
Drain, using the drain hose, before opening the pump filter to remove objects.
Be careful when draining if the water is hot.
• Allow the water to cool down before cleaning the drain pump filter.
1. Open the lower cover
cap (_) with a tool
such as coin.
Turn the drain plug
(_) to pull out the
hose.
2. Unplug the drain plug (_),
allowing the water to flow out.
At this time use a vessel to
prevent water from flowing
onto the floor. When water
does not flow any more, turn
the pump filter (_) open to
the left.
3. Remove any foreign
objects from the pump filter
(_). After cleaning, turn the
pump filter (_) clockwise
and insert the drain plug
(_) to the original place.
Close the lower cover
cap(Q).
To Next Page
Loading...
