LG WM3488HW - Page 21

20
ESUACMOTPMYSRORRE
• Supplied voltage and rated voltage are not matched.
SUPPLIED
VOLTAGE IS NOT
CORRECT
11
• The connector in the DISPLAY PCB ASSEMBLY is
not connected to the connector of NFC PCB
ASSEMBLY.
Reconnect or repair the connector.
• The NFC HARNESS between the NFC PCB
ASSEMBLY and DISPLAY PCB ASSEMBLY is cut
(open circuited).
Replace the DISPLAY PCB ASSEMBLY.
• The NFC PCB ASSEMBLY is out of order/defective.
Replace the NFC PCB ASSEMBLY.
* nC is displayed only in the first screen of the Load
Test Mode.
NFC MODULE
ERROR
12
• NFC version is not matched.
Replace the NFC PCB ASSEMBLY.
• nU is displayed only in the first screen of the Load
Test Mode.
NFC VERSION
ERROR
13
NOTE
When you paused the machine under drying cycle, drying fan motor can be operated to save itself for 30
seconds. And then the machine displays “ ” on the panel.