MOTOR/DAMPER
NOTE
If you pull the dampers apart, the must be
replaced. If you do not separate them, they
can be re-used.
Bolt
Rotor
DAMPER
HINGE,
DAMPER
Disassemble the back cover.
Remove the bolt.
Pull out the rotor.
1
2
3
Unscrew the 2 screws from the tub bracket.
Remove the 6 bolts on the stator.
Unplug the 1 connectors from the stator.
1
2
3
Disassemble the damper hinges from the tub
and base.
1
51
Copyright © 2016 ~ 201
7 LG Electronics Inc. All rights
reserved. Only training and service purposes.
LGE Internal Use Only
To Next Page
Loading...
