35
EN
Symptoms Reason Solution
Washing
machine will not
operate
Control panel has powered off
due to inactivity.
• This is normal. Press the
ENCENDIDO/APAGADO (POWER) button to
turn the washing machine on.
Washing machine is
unplugged.
• Make sure cord is plugged securely into a
working outlet.
Water supply is turned off. • Turn both hot and cold taps fully on.
Controls are not set properly.
• Make sure the cycle was set correctly,
close the door and press the
INICIO/PAUSA (START/PAUSE) button.
Door is open.
• Close the door and make sure that nothing
is caught under the door preventing it from
closing completely.
Circuit breaker/fuse is tripped/
blown.
• Check house circuit breakers/fuses. Replace
fuses or reset breaker. The washing machine
should be on a dedicated branch circuit. The
washing machine will resume the cycle where it
stopped once power is restored.
Control needs to be reset.
• Press the ENCENDIDO/APAGADO (POWER)
button, then reselect the desired cycle and
press the INICIO/PAUSA (START/PAUSE)
button.
INICIO/PAUSA (START/PAUSE)
was not pressed after a cycle
was set.
• Press the ENCENDIDO/APAGADO (POWER)
button then reselect the desired cycle and
press the INICIO/PAUSA (START/PAUSE)
button. The washing machine will shut off if the
INICIO/PAUSA (START/PAUSE) button is not
pressed within 60 minutes.
Extremely low water pressure.
• Check another tap in the house to make sure
that household water pressure is adequate.
Washing machine is too cold.
• If the washing machine has been
exposed to temperatures below freezing
for an extended period of time, allow
it to warm up before pressing the
ENCENDIDO/APAGADO (POWER) button.
Washing machine is heating
the water or making steam.
• The washing machine drum may stop operating
temporarily during certain cycles, while water is
safely heated to a set temperature.
To Next Page
Loading...
