4-8. TR OUB LE S HOOTIN G M ETHOD S A CCOR D IN G TO E R R OR M ESS A G E
For more detailed information for trouble shooting refer to page 46 to 57.
32
Copyright © 2017 LG Electronics Inc. All rights reserved.
Only
training and service purposes.
ERROR DECISION CAUSE FOR ERROR
BASIS OCCURRENCE
REMEDYERROR
WATER LEVEL does
not rise to the set
level in 12 minutes.
Water is not
completely drained
in 12 minutes.
ry unbalance
during spin.
In the second QC
Mode the following
message is displayed.
WATER
SUPPLY
& INLET
V/V.
DRAINAGE
UNBALANCE
OVER
FLOODING
ERROR
Water faucet is closed?
Water supply is interrupted.
rts.
the inlet valve.
Valve connector has bad
contact to the P.W.B ASM.
rain hose located
properly?
rain hose is not lowered.
rain hose is folded or clogged
due to freeze or dirts.
Drain Motor connector to the
P.W.B ASM has bad connection.
ry in the INNER TUB is
Washer is tilted.
S.F S/W is too closed to the
washing tub, or has bad contact.
TOR of Ball
pressure sensor disconnected
or badly tonched?
water faucet.
Wait until water supply is
resumed.
r.
ove.
rain hose at 0.9~1.3m
high. (For pump)
ower.
(For : Non-pump)
rain hose.
rain Motor or correct
the connector contact.
inner tub.
ck and replace S.F S/W.
ck B.P SENSOR
CONNECTOR or replace B.P
sensor
When water is
between 0.9 ~ 1.2 m (36
and 48 inches) above the
Floor.
switch
objects in pressure sensor
switch air hose.
To Next Page
Loading...
