USING YOUR WASHING MACHINE 25
Setting RINSE + SPIN, RINSE + SPIN
Select this option to rinse and spin a load separately from a
regular cycle. This can be helpful in preventing fresh stains
from setting in fabrics. You can change spin speed by
pressing SPIN SPEED respectively.
1
2
Press the POWER button to turn on the washer.
Press the t_sEj button until the RINSE+SPIN indicator
light is lit. (The cyclelight will turn off.)
Press the (._ button to sta_ the cycle. The washer will
start automatically.
Setting SPIN ONLY, SPIN ONLY
This button activates the SPIN ONLY cycle to drain and spin.
1
2
Press the POWER button to turn on the washer.
Press the _ button until the SPIN ONLY indicator light
is lit.
Press the _ button to sta_ the cycle. The washer will
start automatically.
Setting STAIN CARE TM, STAIN CARE TM
STAIN CARETM may be selected as an option with HEAVY
DUTY, COTTON/NORMAL and TOWELS cycles. Wash only
small loads for optimum fabric care. (less than 8 Ibs.)
1
2
Press the POWER button to turn on the washer.
Press the _ button until the STAIN CARETM indicator
light is lit.
Press the _ button to sta_ the cycle. The washer will
_T_RT_
start automatically.
@ NOTE
If you select STAIN CARE TM, the COLDWASH TM option
Setting soak, SOAK
Allows the consumer to remove stains more thoroughly by
specifying additional time for the clothing to soak during
washing. At the end of SOAK, the wash cycle will be started
without drain. Cycle time will be increased by 30 minutes.
It is normal that washer do weak agitation during SOAK
cycle.
@ NOTE
You cannot setect the SOAK option
cycle.
in the TUB CLEAN
Saving energy, COLDWAS_ _TM
Use this option to eliminate using the built-in water heater
booster. For maximum efficiency, wash only small loads. (less
than 8 Ibs.)
N OT E
If you select STAIN CARETM, the COLDWASH TM option J
/
1 Turn the cycle selector knob to the desired cycle.
2 Press t,........The washer will automatically adjust the
cycle settings.
3 Set any other desired options.
4 Press @.
NOTE
* When you select the COLDWASH TM option, wash time
will be increased up to 10 minutes.
. For high wash dfficiency, it is recommended to use
less than 8 pounds.
Adding extra rinse cycle, EXTRA RINSE wA
You can add an extra rinse cycle to the default rinse cycle.
1
2
3
4
Turn the cycle selector knob to the desired cycle.
Press _T_,_,.
- light will turn on.
Press the desired option to use the other options.
- Skip to step 4 to use the default setting without
changing the options.
Press @.
Setting fabric softener of laundry, FABRIC
The fabric softener is dispensed in the final rinse.
FABRIC Select FABRIC SOFTENER button to change final
SOFTENER
rinse type from spray rinse to rinse.
@ NOTE
* Use the FABRIC SOFTENER or EXTRA RINSE options
when selecting the COTTON/NORMAL or HEAVY
. DUTY cycles.
When using the EXTRA RINSE option, the fabric
softener will always be dispensed in the final rinse.
To Next Page
Loading...
