23
4-4. DISASSEMBLY INSTRUCTION
▶ Be sure to unplug the power to repair and replace
electric parts.
ESD (ElectroStatic Discharge) WARNING
Be sure to follow proper ESD and grounding
precautions for diagnosis and repair. If this is not
possible, touch the ground wire on a regular basis to
remove any static charge built up on your person
1) Disassembly of Front Panel and PCB
Assembly
① Remove two screw caps using a sharp tool, then
remove the two front panel attaching screws.
② Push the front panel to the left side then pull it out.
③ Disassemble the protective cover.
④ Disconnect the leads from controller.
⑤ Remove the PCB assembly.
Leads
PCB Assembly
To Next Page
Loading...
