16
3-3. FUNCTION OF EACH BUTTON
1) For Pump Model
Func tion o f e a ch B utto n
NOTE
* For optimizing the washing algorithm, the displayed time may change during washing-increased by a maximum
of 10 minutes (not including spin irregularity correction time) or decrease by a maximum of 4 minutes.
* The control panel may differ according to different models.
Agitation strength button
Hot and cold wash laundry button
Water Level button and
Detergent amount indicator
Remaining wash, reservation
time, and error message display
• Laundry progress is indicated here.
• A flashing indicator means that the
process is in operation, an indicator
which is on but not flashing means
it is awaiting that process and
process indicators that are not lit
means that the process is complete
or was not selected.
• Allows a higher agitation
intensity.
• It is set to Medium intensity
by default (Select is off.)
Select Intensive Wash
by pressing the button.
(Can be set on all courses
except Delicates, Quiet
Wash and Tub Clean.)
Time Delay
(Reservation) button
• Use for laundry
reservation.
• To cancel, press
the power button.
(Refer to page 27)
•
To select hot water, cold water, or warm water washing.
•
Can be changed during operation.
•
If hot wash is selected, laundry will be done with hot water and rinse will
be done with cold water..
•
The preset water temperature for Delicates is Cold water only.
(The laundry can be damaged if Hot water is used)
•
Warm water (Hot + Cold Wash)is automatically selected on the stain care,
Allergy Care, Smart Rinse and Tub Clean cycles.
• Press to manually select
the Water Level.
• It can be changed during
operation.
• Detergent indicator
suggests the recommended
powdered detergent
amount to add.
• During operation this indicates the
remaining wash time.
• If there is a malfunction, the error
message will be displayed to assist
in troubleshooting the problem.
Wash Status display
Wash
Copyright © 2017 LG Electronics Inc. All rights reserved.
Only training and service purposes.
To Next Page
Loading...
