29
When water supply into the tub is not clean or the filter is clogged with particles (such as sand), clean the
filter in the inlet valve occasionally.
(The figure of power cord and water tap may vary according to the country)
To Clean the Filter in the Inlet Valve
Cold water washing
Close the tap before turning off the power.
HOT/COLD(WARM) and then press the
[START/PAUSE] button to remove water
from the machine completely.
• If you always use COLD water, we recommend that a WARM or HOT wash be used at a regular
intervals e.g. every 5th wash should be at least a WARM one.
When you have finished
• Turn off taps to prevent the chance of flooding should a hose burst.
• Always unplug the power cord after use.
After removing the water supply
hose pull out the filter.
Then use a brush to clean the filter.
Turn off the power before
pulling out the cord.
Replace the filter after cleaning it.
1 2
3 4
NOTE
• Before cleaning the filter, the impurities in the water supply hose should be removed.
3-6. CLEANING AND MAINTENANCE
Copyright © 2017 LG Electronics Inc. All rights reserved.
Only training and service purposes.
To Next Page
Loading...
