9
2-3. CONNECT THE DRAIN HOSE
▒ Pump Model
• Do not install the washer where it is directly exposed to sunlight,
wind, rain etc.
• Plug the power cord of this washer into a properly installed
standard electrical outlet that is switched & earthed.
Firmly insert the free end of the drain hose into the drain opening of your
home. Make sure the soft rubber end is completely inside the drain opening.
• If the water valves and drain are built into the wall, fasten the drain hose to one of the water hoses
with the cable tie (ribbed side on inside).
• If your drain is a standpipe, fasten the drain hose to the standpipe with the cable tie provided.
0.9~1.2m
Cable Tie
Cable Tie
0.9~1.2m
To Next Page
Loading...
