ERROR
ERROR DECISION
BASIS
CAUSE FOR ERROR
OCCURRENCE
REMEDY
THERMISTOR
AC, MOTOR
(CLUTCH
MOTOR)
· Thermistor has a bad
connection or failed
· AC motor has a bad
connection or failed
· Clutching is failed
-. Coupling get out of
gear.
-.Coupling is broken.
· Check the connections at the
Thermistor and at the WHITE
3-pin connector at the main
board
· Test thermistor to determine
it is
not detective
· Check the connections at the
AC motor and at the WHITE
6-pin connector at the main
board
· Test AC motor or coupling to
determine it is not detective
· Reseat the connector.
· Replace the thermistor if
necessary.
·Reseat the connector.
· Replace the AC motor if
necessary.
· Replace the coupling or Clutch
housing if necessary.
Power
Failure
ERROR
The washer experienced a
power failure
When occurred a power
failure.
When the power cord is
fallen
off suddenl
y
.
Restart the cycle.
. ( occurs
only in the case of a power
failure and estart the cycle
to eliminate it. It is the
normal phenomenon )
Reconnect the power cord.
·
·
·
·
Coin
Occurs when motor
locked
When foreign object such as
coin, pin, or clip entered the
washing plate
Remove the coin or
f
oreign
object stuck between the
washer vane with pliers,
etc.
Stuc
·
is
·
·
THERMISTOR
Thermistor has a bad
connection or failed
Check the connections at the
Thermistor and at the WHITE
3-pin connector at the main
board
Test thermistor to determine it is
not detective
Reseat the connector.
Replace the thermistor if
necessar.
·
·
·
·
·
42
To Next Page
Loading...
