ERROR DECISION CAUSE FOR ERROR
BASIS OCCURRENCE
REMEDYERROR
v
W
DOOR
SENSOR
MOTOR
LOCKING
v
S
CONNECT W M
S
W
A
c S
B
38
It occurs when the
motor is locked
( When there is a
problem with the
motor )
- Check the connections at the Motor and at
the gray 3-pin (GY3) connector on the main
board.
Test the Motor to determine it is not defective.
- Check resistance at the connections of
the Motor
If result ∞ ohm
- Check the Drain motor to determine it is
not defective.
- Turn the drum to verify the bearings are
not locked
- Re-Assembly the connecter of Motor.
- Replace the Harness motor if necessary
- Replace the Motor if necessary
- Referent to Topic
4. Service Information
4-9. How to Diagnose and Repair by Symptom
10) Spin extraction is not proceeded.
Drain Motor/Clutch. (Page.48)
- Replace the bearings if Necessary
To Next Page
Loading...
