LGMG North America Inc.
Operation and Safety Manual
8
⚫ Check the workstation to avoid any
overhead barriers or other possible
hazards in the work site.
⚫ Pay attention to any crushing
hazards when holding the guard rail
of the platform.
⚫ The operator must follow the
manufacturer’s service rules for
personal protection equipment, the
service rules for the workstation,
and the laws and regulations made
by the local government.
⚫ Observe and follow the traveling
arrow and the turning direction
arrows on the platform controller
and the platform’s label and
nameplate.
⚫ Do not operate the machine on the
line of any crane or movable
overhead machine, unless the crane
controller is locked and/or the
potential bump prevention measure
is taken.
⚫ Dangerous driving or careless
operation when running the machine
are strictly prohibited.
⚫ The platform can be lowered only
when there are no personnel or
barriers below the platform.
⚫ Limit travel speed according to
ground conditions, traffic, road
grade, personnel position, or any
other possible bump factors.
△
! Component Damage Hazards
⚫ Do not charge the batteries with
anything more than a 24V battery
charger.
⚫ Do not use the machine as a ground
for welding. This could cause
damage to the electrical
components on the machine.
△
! Explosion and Fire Hazards
⚫ Do not operate or charge the
machine in a location with a
potential for inflammable or
explosive gas or particles.
△
! Machine Damage Hazards
⚫ Do not use a damaged or
malfunctioning machine.
⚫ Make a complete operational and
function check before each shift.
Attach a tag on a damaged or
To Next Page
Loading...
Need help?
General
