Introduction
2
1.2 Outside Enclosure Overview
The enclosure for the Liqui-tect panel’s controller board comes in two sizes:
•The large enclosure is designed to accommodate the Transformer Module and future compo-
nents, in addition to the controller board.
•The small enclosure is built to hold the controller board only.
Both enclosures are 2-3/4" deep.
Both enclosures have a built-in liquid crystal display (LCD) and a key lock, as shown in the example
below. The metal enclosures accommodate secure conduit fittings and protect components against
external forces and debris.
Figure 1 Small enclosure—external features
The enclosure must be secured to a wall, either flush-mounted or recessed in the wall, as described in
2.0 - Installation. Knockouts and access slots on the top and bottom allow easy connection of wires
and cables (see 3.0 - Connections and Configuration) with either mounting type.
Figure 2 Large enclosure—internal features
LIQUI-TECT PANEL
05-SEP-02 14:04:13
V5.100.0
PRESS =STATUS/SETUP
ESC
Liqui-tect
To Next Page
Loading...