PFCL Elite 6 / PFCL Elite 12
- 31 -
6 INTEGRATION OF PFCL ELITE IN SCADA SYSTEM
PFCL Elite systems have an RS-485 communications channel, so that they can be integrated as an
additional peripheral in SCADA.
They can be connected either directly through an RS-485 bus or integrated into an Ethernet network with an
RS-485 to Ethernet/Modbus converter.
The communication features are defined on the Communications setup screen (section 5.5). The peripheral
number (unit identification number in the network), transmission speed and features of the communications
frame sent (parity, stop bits, etc.) are defined on this screen.
7 MAINTENANCE
The PFCL Elite 6 or PFCL Elite 12 regulator does not require a special type of maintenance. Try to avoid
any form of adjustment, maintenance or repairs while the unit is open. If this cannot be avoided, only qualified
and trained staff must carry out these operations.
Disconnect the unit from all power supplies before performing any connection modifications, relocation,
maintenance or repair operations. If you suspect any operational faults in the unit or in its protection system,
remove the device from service and make sure that it cannot be accidentally reconnected. The design of the
device makes it easy to replace in the event of a fault.
8 TECHNICAL SERVICE
Total or partial reproduction of this publication without previous written consent from INTERNATIONAL CAPACITORS,S.A. is prohibited.
LIFASA INTERNATIONAL CAPACITORS,, SA
c/ Vallés,32 – Polígono industrial Can Bernades
08130 Santa Perpétua de Mogoda (Barcelona) SPAIN
Tel. (+34) 935 747 017 – Fax: (+34) 935 448 433
Web: www.lifasa.com – email: info@lifasa.com
To Previous Page
Loading...
