8 InfraGlow User Manual Lifepro
Wellness Recovery Collection 9
SETTING UP THE INFRAGLOW
• Screw the InfraGlow bulb clockwise into the lamp socket.
• Turn the screws on the outside the lamp clockwise to tighten
them and hold the bulb securely in place. Don't overtighten.
COMPLETE A SKIN SENSITIVITY TEST
Before your first treatment, it is important to perform a skin
sensitivity test to ensure you won’t experience any adverse reactions
to red light therapy. To do a sensitivity test:
• Plug the lamp into a standard wall outlet.
• Holding the lamp about 3–6 inches away, point the LEDs to a
small area on your inner arm.
• Press the power switch on the power cord to turn on the
InfraGlow. Be careful not to accidentally shining the light in your
eyes or looking directly into the LEDs.
• Treat the small area on your inner arm for 10 minutes.
• Turn off and unplug the InfraGlow.
• If your skin feels uncomfortable or hot at any point during the
test treatment, stop using the InfraGlow immediately.
• Wait at least 6 hours after the sensitivity test. If your skin
becomes red and/or itchy, you may be sensitive light therapy and
you should not continue to use the InfraGlow.
GETTING READY TO USE THE INFRAGLOW OPERATING INSTRUCTIONS
Keep this manual for reference.
1
2
1
2
PREPARING FOR YOUR RED LIGHT THERAPY SESSION
• Remove any heavy clothing, shoes, and metal jewelry or metal
accessories (snaps, zippers, buttons, etc.).
• Find a comfortable sofa or chair. You may also wish to grab a
pillow to ensure your treatment session is comfortable.
• Clip the lamp to the edge of a desk, table, or other furniture.
• Make sure the lamp will be about 6–20 inches away from where
you will be sitting or lying.
• Plug the power cable into a wall outlet.
USING THE INFRAGLOW
• Press the power switch on the power cord to turn on the
InfraGlow.
• Complete a red light therapy treatment session between
5–30 minutes, depending on your desired course of treatment.
• Turn off and unplug the lamp.
• Allow the lamp to cool for at least 30 minutes before touching,
storing, or cleaning.
WARNING: Never use the InfraGlow on or over your eyes or eyelids.
WARNING: Never look directly into the LED lights while the device is turned
on as this can damage your eyes. While near-infrared (NIR) light is not visible
to the naked eye, it can be particularly harmful for your eyes.
WARNING: Do not touch the lamp during or after use as the surface of the
lamp can be very hot.
NOTE: We recommend wearing pair of protective eyeglasses (not included).
NOTE: Be sure to remove any metal jewelry and accessories from the area to
be treated, including rings, belts, necklaces, and bracelets, before using. Do
not use over clothing with metal snaps, zippers, or buttons.
Please read the operating instructions and safety instructions before using
the InfraGlow Red Light Therapy Lamp.
To Next Page
Loading...
Need help?
General
