Lifetime 1258 - Section 4: Final Assembly - Filling the Base; Option A: Filling with Sand

35
TOOLS AND HARDWARE REQUIRED FOR THIS PAGE
(150 lb)
SEC

Two adults are required to complete assembly. To prevent serious injuries, the
Pole should be held down by one adult at all times while the Base is being fi lled.
015*0/"'*--*/(8*5)4"/%
(150 lb of sand required)
a. Insert a Base Plug (AZY) into the #BTF"+. in the hole closest to the Pole.
C6TJOHBGVOOFMmMMUIF#BTFXJUITBOEUISPVHIUIFIPMFGVSUIFTUGSPN
UIF1PMFVOUJMUIFTBOEJTKVTUCFMPXUIFIPMF
D 6TJOHUXPBEVMUTTUBOEUIF#BTFVQPOBnBUTVSGBDFBOEmOJTImMMJOH
UIF#BTFXJUITBOE
d. Insert the other Base Plug into the hole furthest from the Pole.
AZY
"+.
AZYY
8"3/*/(
For safety reasons, we recommend that sand be used
instead of water to fi ll the Base. If a leak develops, water
could run out unnoticed, allowing the system to fall over,
resulting in serious personal injuries, or property damage.
If using Water, check the Base carefully for leaks. If a
leak is found, lay the system down on the ground and
call Customer Service. Do not use, stand up, or play on
a leaking system.