Lifetime Freestyle Paddleboard - Fin Installation; Slide the Fin into Place; Secure the Fin

4
SEC 1: Fin Installation
SEC
1.1
Slide the Fin (DNT) up from the bottom of the board. Make sure
the fin is facing the direction shown.
DNT
Note: Your Paddleboard may differ from
the Paddleboard shown, but the same
assembly steps will apply.
!
SEC
1.2
Press the Upper Nub into the notch on top of the Paddleboard.
Make sure to apply firm pressue to the Fin until it pops into
place.
Cross Section of a Paddleboard
Notch
Upper Nub