3
3. Hold the instrument vertically over the specimen.
Ap
ply the instrument foot rapidly but without shock.
Ap
ply just sufficient force to obtain firm contact between
instrument
foot and the specimen. Hold for 1 sec and
ma
x value shows on the display.
4.
Next measurement. Push the ZERO-button and
repeat
step 3 above.
Ma
x measuring mode can be cancelled by press MAX-
button
again. In such case the reading is an instant
value.
Average value
Average
value can given from 2 – 9 measurements.
1.
Push the power Ө-button.
2.
Push the MAX-button. MAX shows on the display.
3.
Push and release the N/Ave-button. Continue push
and
release N/Ave-button to select numbers of
measurment
in the calculation. Wait 3 secunds to the
dis
play shows 0.
4.
Perform first measurments as above.
5. Pushet ZERO-button after each measurement till all
measurements
are made.
Di
splay shows AVE symbolen, average value and
numbers
of measurments.
Calibration
1.
Hold the instrument vertical and make sure the probe
are
free. The displayen show 0. If not push the ZERO-
button.
English
To Next Page
Loading...