Keep the original packaging in order to ship the device if there should be a
guarantee case. Protect the device from severe mechanical stress during transport.
Always transport the device in the original packaging. The installed components are
sensitive to impact and strong vibration.
Proceed as follows to unpack the device:
We recommend inspecting the device for transport damage immediately after it is
delivered. Only acknowledge receipt with reservation (for example on the freight
document), if there is reason to suspect damage. Note the presumed damage on
the freight document and inform the manufacturer.
Carefully remove the packaging. If there is no appropriate agreement concerning
the take-back of packaging material, the packaging remains with the customer.
Environmentally responsible disposal must be ensured in accordance with applicable
disposal guidelines.
Caution – Condensation of water!
Condensation of water is possible due to temperature fluctuations. This can destroy
the device or subsequent malfunctions can result.
Therefore:
After storage or transport in cold weather, or if there are extreme temperature
fluctuations, the device must slowly adjust to the ambient temperature at the
implementation site before it is started up.
If condensation has formed, the device should only be placed in service after a
waiting period of 12 hours.
Attention!
The actuators are designed for use indoors.
Operating temperature: 0°C to 40°C, air humidity: 20 % to 80 %
Transportation and storage conditions: Temperature-20°C to 60°C, air humidity:
5 % to 95 %
Atmospheric pressure range of 76 kPa to 106 kPa
Actuators with special protection categories are labeled accordingly.
To Next Page