Page 39 of 71
If the user adjusts the desk to another position and saves this position, it will overwrite the favourite position
(1 or 2) closest to the current position.
Saving favourite positions 3 and 4
1. Press button shortly to make display toggle through the four favourite positions ( with position
number next to it).
2. Toggle through these four favourite positions in display and choose which one to save current position as.
E.g. a user wants to save the current position as favourite position 3:
3. Press the button and toggle to the with “3” next to it.
4. Press button for two seconds and favourite position is saved.
Note:
Favourite positions 3 and 4 can be disabled via the DPG configurator (from DPG SW ver. 1.29).
Driving to favourite positions
After saving the favourite positions, the user can reach the positions simply by tilting/pressing the DPG1C.
1. Tilt/press and hold - when a saved position has been reached, the desk stops.
2. Release DPG1C within one second.
This way the user can easily change between sitting and standing height without looking at the DPG1C in the
meantime. During desk driving, the display will show the height of the desk. When a favourite position has been
reached, the display shows a and the position number.
The DPG1C stops at all saved favourite positions, which means up to four different positions during the stroke
length of the desk.
When the desk stops at a favourite position, the user can
• keep tilting/presssing the DPG1C for more than one second
or
• release the DPG1C and immediately tilt/press it again.
The desk will move past the favourite position and continue its movement.
Figure 36: Tilt/press to drive desk
To Next Page
Loading...
