8. Insert the glass end of the new bulb into the parking lamp assembly
socket. When the grooves in the plastic base are aligned, push the bulb
into the socket until the plastic base contacts the rear of the socket.
9. To complete installation of the parking lamp/turn signal assembly,
follow the removal procedures in reverse order.
Replacing foglamp bulbs
The halogen bulb contains gas under pressure. The bulb may
shatter if the glass envelope is scratched or if the bulb is
dropped. Handle the bulb carefully. Grasp the bulb only by its
base. Avoid touching the glass envelope.
1. Disconnect the electrical
connector from the back of the
foglamp assembly (the
accompanying artwork represents
the rear side of the foglamp
retaining bracket).
Maintenance and care
163
To Next Page
Loading...
