• Keep the buckle release button
pointing up and away from the safety
seat, with the tongue between the
child seat and the release button, to
prevent accidental unbuckling.
• Place the vehicle seat upon which the
child seat will be installed in the upright
position.
• Put the safety belt in the automatic
locking mode. See Step 5. This vehicle
does not require the use of a locking
clip.
Perform the following steps when installing
the child seat with combination lap and
shoulder belts:
Note: Although the child seat illustrated
is a forward facing child seat, the steps
are the same for installing a rear facing
child seat.
Standard safety belts
2. After positioning the child safety seat
in the proper seating position, pull
down on the shoulder belt and then
grasp the shoulder belt and lap belt
together behind the belt tongue.
3. While holding the shoulder and lap belt
portions together, route the tongue
through the child seat according to the
child seat manufacturer's instructions.
Be sure the belt webbing is not
twisted.
17
MKZ (CC9) , enUSA
Child Safety
To Next Page
Loading...
