9. Tighten the clamp (A).
10. The transmission fluid level indicator
can now be accessed.
Checking the fluid level
Low fluid level
If the fluid level is below the MIN range of
the dipstick, add fluid to reach the hash
mark level.
Note: If the fluid level is below the MIN
level, do not drive the vehicle. An underfill
condition may cause shift or engagement
concerns or possible damage.
Correct fluid level
The transmission fluid should be checked
at normal operating temperature
180°F-200°F (82°C-93°C) on a level surface.
The normal operating temperature can be
reached after approximately 20 miles (30
kilometers) of driving.
The transmission fluid level should be
targeted within the cross-hatch area if at
normal operating temperature 180°F-200°F
(82°C-93°C).
High fluid level
If the fluid level is above the MAX range
of the dipstick, remove fluid to reach the
hashmark level.
Note: Fluid level above the MAX level may
cause shift or engagement concerns or
possible damage. High fluid levels can be
caused by an overheating condition. If
your vehicle has been operated for an
extended period at high speeds, in city
traffic during hot weather or pulling a
trailer, the vehicle should be turned off
until normal operating temperatures are
reached. Depending on vehicle use,
cooling times could take up to 30 minutes
or longer.
Adjusting Automatic Transmission Fluid
Levels
257
MKZ (CC9) , enUSA
Maintenance
To Next Page
Loading...
