Displaying the Factory-Set Code
Note: You will need to have two
programmed intelligent access keys for this
procedure.
To display the factory-set code in the
information display:
E170454
1. Open the center console lid.
2. Place the first programmed key in the
backup slot.
3. Press the AUTO-START-STOP button
once and wait a few seconds.
4. Press the AUTO-START-STOP button
again and remove the key.
5. Within ten seconds, insert the second
programmed key into the backup slot,
and then press the AUTO-START-STOP
button.
The factory-set code will appear in the
information display for a few seconds.
Note: The code may not display until after
any other warning messages first display.
78
Locks
To Next Page
Loading...
Need help?
General
