Lincoln 2015 NAVIGATOR - Comfort

2015 NAVIGATOR
18 19
PowerFold® Third-Row Seat*
The 60/40 split-folding bench seat uses a power-activated
seatback release. Fold one side or both down for more flexibility.
The controls are located on the right-hand rear quarter trim
panel that is accessible from the liftgate area.
Note: Make sure you unfasten all of the safety belts.
To lower:
1. Make sure that the head restraints are folded down first.
2. Press and hold the “FOLD” control. Release the control once
the seats fold completely.
3. To return the seatback to its original position, press and hold the
“UP” control. Release the control once the seats return to the
upright position.
Note: The power-folding seats operate for
10 minutes after you switch the ignition off. The
transmission must be in park (P) and the liftgate
or liftgate glass must be open.
E-Z Entry into the Third-Row Seats*
The feature allows for easier entry and exit to
and from the third-row seats.
To enter the third-row seating area:
1. Fold the head restraint forward.
2. Pull up on Lever 1.
3. Fold down the second-row seat and
release the handle.
4. Pull the handle up again until the
seatreleasesfromtheoor.
5. Push the seat upward and fold it away
from the third row.
To return the seat to an upright
seating position:
1. Pushtheseatdownandlatchittotheoor.
2. Bring the seatback to an upright position.
It should lock into position.
3. Lift up on the head restraint until it locks
into its original position.
*if equipped
To program position 1, switch the ignition on. Move the memory
features to your preferred position. Press and hold the 1 button for
about two seconds until you hear a tone. Use this same procedure to
set the second position by using the 2 button . You can now use
these controls to recall the set memory positions.
You can also program your memory seats to your transmitter. That
way, when you unlock your door with the transmitter, your memory
features automatically move into your saved position. See the Seats
chapter in your Owner's Manual for more details.
Moonroof*
You can open or close the
sliding shade manually after
you close the moonroof. Pull
the shade toward the front
of the vehicle to close it.
The moonroof control is on
the overhead console. To
open, press and release the
SLIDE control. The moonroof
stops short of the fully opened position. To fully open the moonroof,
press and release the SLIDE control again. To close, pull and release
the SLIDE control. Press and release the TILT control to vent the
moonroof. Pull and hold the TILT control to close the moonroof.
Comfort
Front Climate Controlled Seats*
To use the heated seats, press the left side of the button . For
cooled seats, press the right side of the button . Press the desired
button repeatedly to cycle through the settings, from the highest to the
lowest, and then off. More indicator lights mean higher settings. You
can also use the controls in the MyLincoln Touch touchscreen.
Second-Row Controls*
Located on the rear of the center console, auxiliary climate and heated
seat controls let second-row passengers make adjustments and power
smaller accessories independently from the front-row controls.
Memory Seat Feature
The memory function saves and recalls the positions of the driver seat,
power mirrors, adjustable pedals and steering column. Use the control
located on the side of the driver’s seat to program and then
recall saved memory positions.
*if equipped
Lever 1
Position 2
Position 3