After securing, return the bed to the transporting position, then slacken the winch wire
rope slightly to prevent downward pull as bumps are encountered during transport.
Note: Make sure that the ignition switch is in the OFF position, the vehicle is in Park and
parking brake is set.
BRAKE-SHIFT INTERLOCK OVERRIDE:
Use the brake-shift interlock override to move the transmission from the Park position in
the event of a malfunction.
Caution: Prior to performing this procedure secure the vehicle and ensure it will not roll.
Deploy wheel chocks if needed.
1. Apply the parking brake and turn the ignition off before performing this procedure.
2. Carefully remove the access plug on the side of the center console.
3. Apply the brake pedal. Using a suitable tool (for example, a screwdriver), push the
brake-shift interlock override lever forward while pulling the gearshift lever out of Park
(P) and into Neutral (N).
4. Install the access plug on the side of the center console.
5. Apply the brake pedal, start the vehicle, and release the parking brake.
To Next Page
Loading...
