Lincoln 83167 User Manual

the
centralized
lubrication system having a single
line circuit of SL-1, SLS-11, SL-32,
It is an air operated reciprocating
pump that discharges an established
amount of lubricant *(.11 cu. in.) into
*Based on lubricants that are free
of entrapped air. Lubricants that are
aerated will reduce output of pump.
FILL RESERVOIR
Use 81834 Manual Filler Pump to fill reservoir through the filler
fitting in the pump body. Attach coupler on delivery hose to filler.
Stroke filler pump handle until lubricant weepage is noted at air
vent hole in reservoir (lower portion of follower must rise beyond
air vent hole to expel entrapped air from lubricant).
Model No. 83167
AIR OPERATED GREASE PUMP
Series "H"
RATIO
LUBRICANT OUTPUT
(cu. in.)
RESERVOIR
AIR
LUBRICANT
LUBRICANT OPERATING PRESSURE (PSI)
PER
CYCLE
PER MIN.
(@100PSI)
CAPACITY
INLET
OUTLET
TYPE OF
SYSTEM
MINIMUM
MAXIMUM
RECOM-
MENDED
40:1
*.11
12
12 LBS.
1/8"
NPTF(F)
3/4"
NPTF(F)
SL-1
SL-11
1,850
3,550
2,500
SL-32
SL-33
1,200
3,550
1,500
TYPICAL
INSTALLATION
The 83167 Pump is used as
pumping unit for a
OR SL-33 Injectors.
the circuit for each pump cycle.
NOTE: When fillingthe reservoir, cautionshouldbe used as extreme
pressure can cause damage to reservoir and follower assembly.
Section
- C8
One Lincoln Way
Copyright 2005
St. Louis, Missouri 63120-1578
Printed in U.S.A.
Page
- 85T
(314) 679-4200
JULY - 2005
FORM 403574

Lincoln 83167 Specifications

General

Brand	Lincoln
Model	83167
Category	Water Pump
Language	English

Summary

Instructions for Pump Using 85209 Control Panel

To Prime System Supply Lines

Procedure to prime supply lines by loosening plugs and venting air.

Important Notes

Refer to Owner/Operator Manual C8 259 for programming the 85209 controller.

Feeder Lines

Fill feeder lines with lubricant before connecting to injectors or bearings.

Injectors

Check injectors for proper operation by observing indicator stem movement.

Operation

System cycle initiated by 85530, air solenoid energizes pump, pressure switch stops pump.

Instructions for Pump Using 83820 Time Control

To Prime System Supply Lines

Procedure to prime supply lines by loosening plugs and venting air.

Important Notes

Reset the delay relay to desired interval for system planning.

Feeder Lines

Fill feeder lines with lubricant before connecting to injectors or bearings.

Injectors

Check injectors for proper operation by observing indicator stem movement.

Vent Valve

Describes the 83948 Vent Valve operation and its role in pressure venting.

Safety Unloader

Details the 90942 Safety unloader, its function and factory settings.

Operation

Timer activates pump via micro-switch and solenoid valve; pressure control stops pump.

Troubleshooting: What to Do If

Guidance for pump losing prime, fouled parts, or pump failure.