Lincoln 85250 - User Manual

Page
Section
- F40
- 31C
Form 404308SEPT - 2011
Models No. 85250 & 85252
AIR OPERATED EJECTOR
OWNER/OPERATOR MANUAL
It is the responsibility of the Owner/Operator to properly use and maintain this equipment.
The Instructions and Warnings contained in this manual shall be read and understood by the Owner/Operator prior to operating
this equipment.
It is the responsibility of the Owner/Operator to maintain the legibility of all Warning and Instruction labels.
The Owner/Operator shall retain this manual for future reference to important Warnings. Operating and Maintenance
Instructions.
DO NOT exceed the stated maximum working pressure of
the elector or of the lowest rated component in your system.
DO NOT alter or modify any part of this equipment.
DO NOT operate this equipment with combustible gas.
DO NOT attempt to repair or disassemble the equipment
while the system is pressurized.
TIGHTEN all uid connections securely before using this
equipment.
ALWAYS read and follow the fluid manufacturer’s
recommendations regarding uid compatibility, and the use
of protective clothing and equipment.
CHECK all equipment regularly and repair or replace
worn or damaged parts immediately.
IMPORTANT: Failure to heed these warnings including
misuse, over pressurizing, modifying parts, using
incompatible chemicals and uids, or using worn or
damaged parts, may result in equipment damage and/or
serious personal injury, re, explosion, or property damage.
One Lincoln Way
St. Louis Missouri 63120-1578
(314) 579-4200
Copyright 2011
Printed in USA.
Model 85250: Used with EPDM Compatible Materials.
Model 85252: Used Specically with Petroleum Based
Materials.
©
© Indicates change

Summary

Operation

Ejector Operation Description

Explains the inline double power air cylinder mechanism and its dispense cycle.

Service and Disassembly

Disassembly of Air Components

Detailed steps for taking apart the air-related sections of the ejector.

Disassembly of Wetted Components

Step-by-step guide for dismantling the fluid-contacting parts of the ejector.

Reassembly Procedure

Instructions on how to put the ejector back together after disassembly.

Adjustment Procedure

Guide on how to adjust the ejector's output using the adjustment screw.

Specifications

Ejector Performance Data

Details on priming pressure, air pressure, output per cycle, ratio, and adjustment rate.

Wetted Parts Materials

Lists the materials used for wetted components like carbon steel, Viton, and EPDM.

Lincoln 85250 Specifications

General

Brand	Lincoln
Model	85250
Category	Industrial Equipment
Language	English