The system can also bring your vehicle to a
complete stop and may resume going forward
in stop-and-go trac. Adaptive Cruise Control
with Lane Centering* is designed to help
keep your vehicle in the center of the lane by
applying continuous assistance steering torque
input toward the lane center on highways. To
switch it on, press the
button. The system
will only activate when you have both hands
on the wheel and the system detects both
lane markings.
Intelligent adaptive cruise control allows you
to set the vehicle speed to the speed limit
detected by the speed sign recognition system.
Note: Driving aids do not replace the need to
watch where the vehicle is moving and brake
when necessary.
Refer to the Adaptive Cruise Control chapter
in your Owner’s Manual for safety information,
more details and limitations.
4 Service Engine Soon Light
Illuminates briey when you switch the ignition
on. If it remains on or blinks after you start the
engine, the On-Board Diagnostics (OBD-II)
system has detected a problem. Drive in a
moderate fashion and contact your authorized
dealer as soon as possible.
5 Voice Recognition
Press to access voice commands.
6 Media Controls
Press up to increase volume level.
Press down to decrease volume level.
|⊳ or ⊲| Press to the right or left to access the
previous or next media selection.
7 Steering Wheel Controls
Press to scroll through the on-demand
display screens.
Press to the left to enter the
media submenu.
Press to the right to access phone
mode or to answer a phone call.
Press up to enter the
navigation submenu.
Press down to enter the
settings submenu.
The following controls are only visible when you
are inside the feature menus:
Press to exit the submenu.
Press to the left to exit a submenu.
Press to the right to choose and confirm
settings or messages.
You can also use the steering wheel buttons
to control the Head Up Display* and information
display options.
8 Autowipers
The autowiper system turns the wipers on only
when moisture is present on the windshield.
Push the wiper stalk up one position to activate
the autowipers. Use the rotary control to
adjust the sensitivity of the autowipers. A low
sensitivity means the wipers turn on when the
system detects a large amount of moisture on
the windshield. A high sensitivity means the
wipers turn on when the rain sensor detects
a small amount of moisture on the windshield.
Autowipers default to on and remain on until
you switch them o in the touchscreen.
Note: Make sure that you switch o this feature
before entering a car wash.
Instrument Panel
1 Refueling*
For plug-in hybrid vehicles, press to open the
fuel ller door. See page 30 for information about
refueling your vehicle.
2 Lighting Control
Press the toggle switch up or down to make a
selection. An indicator illuminates next to the
active selection.
Headlamps on
Autolamps
Parking lamps, instrument panel lamps,
license plate lamps and rear lamps
Lamps o
Note: The lighting control defaults to autolamps
each time you switch your vehicle on.
3 Adaptive Cruise Control*
Adaptive Cruise Control adjusts your speed to
maintain a set distance between your vehicle
and the vehicle in front of you in the same lane.
You can select from one of four gap settings by
pressing the gap controls on the steering wheel.
To set a cruise speed, switch cruise control on
by pressing the button. Once you switch
the system on, the control icons display. These
controls are pressed from behind the steering
wheel. Accelerate to your desired speed and
press the SET+ or SET– button. An indicator light,
the current gap setting and your set speed appear
in the information display. Press the CANCEL
button to cancel cruise control, press the RESUME
button to return to the set speed and gap setting
and press the button or switch o the ignition
to turn cruise control o.
*if equipped
54
2022 AVIATOR
4614487_22a_Aviator_QRG_040521_readers.indd 4-54614487_22a_Aviator_QRG_040521_readers.indd 4-5 4/8/21 4:12 PM4/8/21 4:12 PM
To Next Page
Loading...
