• Press the setup button - The message center then displays the next
menu selection in its list.
• Press the reset button - The message center then proceeds to the
next sequence/step (3) below.
• The message center sends/issues the “Autolamp Delay Command” to
the body security module (BSM).
• The body security module responds within 100 milliseconds with next
auto lamp exit delay time.
3. Next sequence/step number is one (1) steps 1,2,3,4&5arerepeated
until exit via step 2.
4. The message center displays the next menu selection.
Daytime running lamps (DRL) (if equipped)
To activate DRL:
• the ignition must be in the ON position and
• the headlamp control is in the
or position
• the parking brake must be disengaged.
Always remember to turn on your headlamps at dusk or during
inclement weather. The Daytime Running Light (DRL) System
does not activate your tail lamps and generally may not provide
adequate lighting during these conditions. Failure to activate your
headlamps under these conditions may result in a collision.
High beams
Push the lever toward the
instrument panel to activate. Pull
the lever towards you to deactivate.
INT2
OFF
O
F
F
INT1
2005 Aviator f/k/a Navigator LS (231)
Owners Guide (post-2002-fmt)
USA_English (fus)
Lights
105
To Next Page
Loading...
