Do not sit on top of a buckled safety belt to avoid the
BeltMinder娂 chime. Sitting on the safety belt will increase the
risk of injury in an accident. To disable (one-time) or deactivate the
BeltMinder娂 feature please follow the directions stated below.
One time disable
Any time the safety belt is buckled and then unbuckled during an
ignition ON cycle, the BeltMinder娂 will be disabled for that ignition
cycle only.
Deactivating/activating the BeltMinder姟 feature
Read Steps1-9thoroughly before proceeding with the
deactivation/activation programming procedure.
The BeltMinder娂 feature can be deactivated/activated by performing the
following procedure:
Before following the procedure, make sure that:
• The parking brake is set
• The gearshift is in P (Park)
• The ignition switch is in the OFF position
• All vehicle doors are closed
• The driver’s safety belt is unbuckled
• The parklamps/headlamps are in OFF position (If vehicle is equipped
with Autolamps, this will not affect the procedure.)
To reduce the risk of injury, do not deactivate/activate the Belt
Minder feature while driving the vehicle.
1. Turn the ignition switch to the RUN (or ON) position. (DO NOT
START THE ENGINE)
2. Wait until the safety belt warning light turns off. (Approximately 1–2
minutes)
• Steps 3-5 must be completed within 60 seconds after the warning light
turns off or the procedure will have to be repeated.
3. At a moderate speed, buckle then unbuckle the safety belt three
times, ending with the safety belt unbuckled. This can be done before or
during BeltMinder娂 warning activation.
4. Turn on the parklamps/headlamps, turn off the parklamps/headlamps.
2005 Aviator f/k/a Navigator LS (231)
Owners Guide (post-2002-fmt)
USA_English (fus)
Seating and Safety Restraints
199
To Next Page
Loading...
