Lincoln MKX - Page 96

3. Hold the OK button as prompted until you see a message that the key
is restricted.
MyKey威 is successfully programmed. Make sure you label it so you can
distinguish it from the admin keys. Note: To program the optional
settings go to Step 2 in the Programming MyKey威 optional settings
section. If your vehicle is equipped with remote start, see the Using
MyKey威 with remote start systems section.
Note: All MyKeys威 can be cleared within the same key cycle that it was
created, otherwise an admin key is required to clear the MyKey威
programming. To clear all MyKeys威 go to Step 2 in the Clear MyKey威
section.
Programming MyKey威 optional settings
Turn the ignition on using an admin key. To program the optional
settings, use the message center buttons to do the following:
1. Get into main menu, select SETTINGS then MYKEY by pressing the
OK button or the right arrow button.
2. Use the up and down arrow buttons to get to any optional feature.
3. Press the right arrow button to bring up settings of each item.
4. Press OK button or right arrow button to make your choice.
Clear MyKey威
To reset all MyKeys威 as admin keys do the following:
1. At the main menu screen select SETTINGS then MYKEY by pressing
OK or the right arrow key.
2. Press the down arrow key to get to CLEAR MYKEYS.
3. Hold OK until you see ALL MYKEYS CLEARED.
Check MyKey威 system status
The vehicle’s message center information menu will provide the status of
the following MyKey威 parameters:
• MYKEY MILES (km) — This odometer only tracks distance when a
MyKey威 is used. If distance does not accumulate as expected, then
the MyKey威 is not being used by the intended user. The only way to
reset this odometer to zero is by clearing MyKey威. If this odometer is
lower than the last time you checked, then the MyKey威 system has
been recently cleared.
• # MYKEY(S) PROGRAMMED — Indicates how many MyKeys威 are
programmed to the vehicle. Can be used to detect deletion of a
MyKey威.
Locks and Security
96
2012 MKX (mkx)
Owners Guide, 1st Printing
USA (fus)