Examples of acceptable condensation are:
• Presence of thin mist (no streaks, drip
marks or droplets).
• Fine mist covers less than 50% of the
lens.
Examples of unacceptable moisture (usually
caused by a lamp water leak) are:
• Water puddle inside the lamp.
• Large water droplets, drip marks or
streaks present on the interior of the lens.
Take your vehicle to a dealer for service if
any of the above conditions of unacceptable
moisture are present.
Replacing Bulbs
For replacing bulbs, see your authorized
dealer.
BULB SPECIFICATION CHART
Replacement bulbs are specified in the chart
below. Headlamp bulbs must be marked with
an authorized “D.O.T.” for North America to
make sure they have the proper lamp
performance, light brightness, light pattern,
and safe visibility. The correct bulbs will not
damage the lamp assembly or void the lamp
assembly warranty and will provide quality
bulb illumination time.
Trade nameFunction
LEDHeadlamp high beam
LEDHeadlamp low beam
LEDSide marker lamp - front
LEDPark lamp - front
LEDTurn lamp - front
LEDTail and brake lamp - high series
LEDTail and brake lamp - low series
LEDReverse lamp
303
MKZ (CC9) Canada/United States of America, enUSA, Second Printing
Maintenance
To Next Page
Loading...
