Lincoln Nautilus 2019 - Instrument Panel; Power Adjustable Steering Column; Electric Parking Brake; Service Engine Soon Light

5
2019 Nautilus
3 Lane Keeping System
See page 16 for more information.
4 Service Engine Soon Light
Illuminates briey when you switch the
ignition on. If it remains on or blinks after you
start the engine, the On-Board Diagnostics
(OBD-II) system has detected a problem.
Drive in a moderate fashion and contact your
authorized dealer as soon as possible.
5 Information Display
Provides information about various systems in
your vehicle. Use the steering wheel controls
to choose and conrm settings and messages.
Refer to the Information Displays chapter of
your Owner’s Manual for more information.
6 Steering Wheel Controls
VOL +
or VOL -
Press to increase or decrease
volume levels.
|⊳ or ⊲|
Press to access the previous or next
media selection.
Press to silence the
current media.
Press to exit a menu.
Press to access voice recognition.
Press to end a phone call.
Press to access phone mode
or to answer a phone call.
You can also use the steering wheel buttons
to control the SYNC 3 screens including the
audio, settings, navigation and information
display options.
Use the toggle control and the OK button to
select and confirm options for SYNC 3.
7 Keyless Starting
You can start your vehicle by pressing the
START STOP button while fully pressing down
on the brake pedal. Press the button again,
without applying the brake, to switch the
engine off. If you leave your vehicle idling for an
extended period of time, the engine shuts down
automatically. Before this happens, a message
appears in the information display, allowing you
time to override the shutdown feature. If you try
to leave the vehicle when it is still on, the horn
will sound twice.
Note: A valid key must be inside the vehicle
for the ignition to start.
8 Push Button Shift Transmission
Your vehicle includes an electronic transmission.
The shift buttons are on the instrument panel.
Putting Your Vehicle in Gear
A. Fully press down on the brake pedal,
then press and release one of the PRNDS
buttons to select your gear.
B. The selected gearshift button lights and the
information display shows the selected gear.
Release the brake pedal and your
transmission remains in the selected gear.
Note: When entering an automatic car wash,
always put your vehicle in Stay in Neutral
mode. To put your vehicle in Stay in Neutral
mode, make sure your vehicle is stationary first,
and then:
A. Press the neutral (N) button once. The
information display prompts you to press
the neutral (N) button again to enter Stay in
Neutral mode.
B. Press the neutral (N) button again. The
message display confirms when your
vehicle enters Stay in Neutral mode. The
neutral (N) button flashes continuously to
confirm your selection.
To exit Stay in Neutral mode, select
another gear.
9 Hazard Warning Control
10 Auto Hold
See page 17 for more information.
Instrument Panel
1 Power Adjustable Steering Column*
Use the control on the left side of the
steering column to adjust the position.
2 Electric Parking Brake
The electric parking brake switch replaces
the conventional hand brake. The switch
is on the instrument panel. To apply the
electric parking brake, pull the switch
up. The brake system warning lamp
ashes for approximately 2 seconds,
and then illuminates to conrm that you
applied the parking brake. To release the
electric parking brake manually, switch
the ignition on, press the brake pedal
and then press the switch down. The
brake system warning lamp turns o. Your
vehicle automatically releases the parking
brake when the driver door is closed, the
accelerator pedal is pressed and no faults
are detected in the parking brake system.
Note: If the electric parking brake warning
lamp stays on, then the electric parking brake
did not automatically release. You must release
the electric parking brake using the switch.
4
*if equipped