Lincoln NAUTILUS 2025 - Adjusting the Steering Wheel; Resetting the Stopping Position

1. Press any area on the control to activate
the control mirror in the instrument
cluster display. The control mirror
highlights the locations you press. Any
applicable text of the active location
appears below the control mirror in the
instrument cluster display.
Note: Applicable text displays in the
instrument cluster for right-hand controls
only.
2. Using the control mirror, press the
corresponding location on the steering
wheel control to select the option you
prefer.
Note: The instrument cluster display control
mirror times out after a few seconds.
ADJUSTING THE STEERING WHEEL
WARNING: Do not adjust the steering
wheel when your vehicle is moving.
Note: Make sure that you are sitting in the
correct position. See Sitting in the Correct
Position (page 155).
E390750
Use the control on the side of the steering
column to adjust the position.
To adjust:
• Tilt: Press the top or bottom of the
control.
• Telescope: Press the front or rear of the
control.
RESETTING THE STOPPING
POSITION
Note: The steering wheel stops when it
detects an obstruction. This sets a new
stopping position.
To reset the steering column to its normal
stopping position:
1. Confirm there is nothing obstructing the
motion of the steering column.
2. Press and hold the steering column
control until the steering column stops
moving.
3. Press the steering column control again.
Note: The steering column may start to move
again.
102
Nautilus (CFG) Canada/Mexico/United States of America, enUSA, Edition date: 202405, DOM
Steering Wheel