REPLACING THE REAR WIPER
BLADES
1. Lift the wiper arm.
Note: Do not hold the wiper blade to lift the
wiper arm.
Note: Do not lift the wiper arm beyond the
limited service-up position, as this might
cause damage to the wiper arm. The limited
service-up position is intended to protect the
wiper arm against car washes.
2. Remove the wiper blade.
Note: Make sure that the wiper arm does
not spring back against the glass when the
wiper blade is not attached.
3. To install, reverse the removal procedure.
Note: Make sure that the wiper blade locks
into place.
WASHERS
WASHER PRECAUTIONS
WARNING: If you operate your
vehicle in temperatures below 41°F (5°C),
use washer fluid with antifreeze protection.
Failure to use washer fluid with antifreeze
protection in cold weather could result in
impaired windshield vision and increase
the risk of injury or accident.
Do not operate the washers when the
washer reservoir is empty. This could cause
the washer pump to overheat.
USING THE WINDSHIELD WASHER
Pull the lever toward you to
operate the windshield washer.
107
Nautilus (CFG) Canada/Mexico/United States of America, enUSA, Edition date: 202405, DOM
Wipers and Washers
To Next Page
Loading...
