Note: To use remote start with Lincoln Way
or Phone as a Key, enable the modem. See
Connecting Lincoln Way to the Modem
(page 461).
ENABLING REMOTE START
1. From the settings menu, press Vehicle.
2. Press Remote Start Setup.
3. Switch Remote Start on or off.
Note: To remote start with Lincoln Way,
make sure that the modem is enabled. See
Connecting Lincoln Way to the Modem
(page 461).
REMOTELY STARTING AND
STOPPING THE VEHICLE
Remotely Starting the Vehicle
Press the button on the remote
control.
Within three seconds, press the
button on the remote control.
Within three seconds, press the button again.
Note: You can also use the Lincoln Way app
to start the vehicle.
Note: The turn signals flash twice.
Note: The parking lamps turn on when the
vehicle is running.
Note: The horn sounds if the system fails to
start.
Note: All other vehicle systems remain off
when you have remotely started the vehicle.
Note: The vehicle remains secured when
you have remotely started the vehicle. A
valid key must be inside your vehicle to
switch your vehicle on and drive your
vehicle.
Remotely Stopping the Vehicle
Press the button on the remote
control.
EXTENDING THE REMOTE START
DURATION
To extend the remote start duration during
remote start, do the following:
Press the button on the remote
control.
Within three seconds, press the
button on the remote control.
Within three seconds, press the
button again.
If the duration is set to 15 minutes, the
duration extends by another 15 minutes. This
provides a total of 30 minutes.
Note: Remote start can only be extended
once.
Note: A maximum of two remote starts, or
one remote start with an extension, are
allowed. To reset the restart procedure
switch the vehicle to on, then to off.
140
Nautilus (CFG) Canada/Mexico/United States of America, enUSA, Edition date: 202405, DOM
Remote Start