Lincoln NAUTILUS 2025 - Using Auto Hold; Auto Hold Indicators

E323448
Press the button on the center
console. The button illuminates
when you switch the system on
and press again to switch the system off.
Note: You can only switch the system on
after you close the driver door and start the
engine.
Note: The system remembers the last setting
when you start your vehicle.
Make sure you switch the system off before
towing with your vehicle or before using an
automatic car wash.
USING AUTO HOLD
1. Bring your vehicle to a complete stop.
The auto hold active indicator illuminates
in the instrument cluster display.
2. Release the brake pedal. The system
holds your vehicle at a standstill. The
auto hold active indicator remains
illuminated in the instrument cluster
display.
3. Apply the accelerator and drive off in a
normal manner. The system releases the
brakes and the auto hold active indicator
switches off.
Note: The system only activates if you apply
enough pressure to the brake pedal to bring
the vehicle to a standstill.
Note: Under certain conditions, the system
could apply the electric parking brake. The
brake system warning lamp illuminates. The
electric parking brake releases when you
press the accelerator pedal.
See
Automatically Releasing the Electric
Parking Brake (page 229).
Note: The system switches off if you shift
into reverse (R) or neutral (N) while pressing
the brake pedal.
There could be actions that can cause the
auto hold system not to work when the
following occur:
• Your vehicle is in temporary neutral
mode.
• The driver door is open.
• You shift into reverse (R) or neutral (N)
before the system is active.
AUTO HOLD INDICATORS
E323448
Illuminates when the system is
active.
E323449
Illuminates when the system is on
but cannot hold your vehicle at a
standstill at this particular time.
239
Nautilus (CFG) Canada/Mexico/United States of America, enUSA, Edition date: 202405, DOM
Auto Hold