You can set-up a trailer to work with the blind
spot information system through the
touchscreen by using the add trailer menu.
1. Input the trailer name and trailer type,
conventional, gooseneck or fifth wheel,
then save to continue trailer setup.
Note: The system only supports conventional
trailers.
2. Trailer width measurement. Measure the
width at the front of the trailer. It is not
measured at the widest point of the
trailer. The maximum width at the front
of the trailer the system can support is
8.5 ft (2.6 m).
Note: If the trailer is a bike rack or cargo
rack with electrical lighting, enter a length
of around 3 ft (1 m). Cross traffic alert remains
on for trailers with a length of 3 ft (1 m) or
less.
Note: The system requires proper
measurement and measure entry to properly
function.
SELECTING A TRAILER
When you connect a trailer to your vehicle,
the trailer set up menu appears in the
touchscreen. This menu allows you to set up
a new trailer or choose from a previously set
up trailer. A warning message appears and
the system turns off if you do not choose or
add a new trailer.
Note: The warning message may not appear
until your vehicle reaches 22 mph (35 km/h).
BLIND SPOT INFORMATION
SYSTEM INDICATORS
When blind spot information
system detects a vehicle, an alert
indicator illuminates in the exterior
mirror on the side the approaching vehicle
is coming from. If you turn the turn signal on
for that side of your vehicle, the alert
indicator flashes.
307
Nautilus (CFG) Canada/Mexico/United States of America, enUSA, Edition date: 202405, DOM
Blind Spot Information System
To Next Page
Loading...
