SWITCHING PRE-COLLISION
ASSIST ON AND OFF
You cannot switch the system off.
Adjusting the Pre-Collision Assist
Settings
You can adjust the following settings by
using the touchscreen controls in the
pre-collision assist menu:
• Change alert sensitivity to one of three
possible settings.
• If required, switch automatic emergency
braking on or off.
• If required, switch evasive steering assist
on or off.
Note: Automatic emergency braking and
evasive steering assist automatically turn on
every time you start your vehicle.
Note: If you switch automatic emergency
braking off, evasive steering assist switches
off.
LOCATING THE PRE-COLLISION
ASSIST SENSORS
The camera is mounted on the windshield
behind the interior mirror.
The radar sensor is in the lower grille.
If a message regarding a blocked sensor or
camera appears in the information display,
something is obstructing the radar signals or
camera images. The radar sensor is behind
the fascia cover in the center of the lower
grille. With a blocked sensor or camera, the
system may not function, or performance
may reduce. See Pre-Collision Assist –
Frequently Asked Questions (page 325).
Note: Proper system operation requires a
clear view of the road by the camera. Have
any windshield damage in the area of the
camera's field of view repaired.
Note: If something hits the front end of your
vehicle or damage occurs and your vehicle
has a radar sensor, the radar sensing zone
could change. This could cause missed or
false vehicle detections. Have your vehicle
serviced to have the radar checked for
proper coverage and operation.
321
Nautilus (CFG) Canada/Mexico/United States of America, enUSA, Edition date: 202405, DOM
Pre-Collision Assist
To Next Page
Loading...
