Do not use supplemental engine oil additives
because they are unnecessary and could
lead to engine damage that the vehicle
warranty may not cover.
1. Clean the area surrounding the engine
oil filler cap before you remove it.
2. Remove the engine oil filler cap.
3. Add engine oil that meets our
specifications. See Engine Oil (page
387).
4. Reinstall the engine oil filler cap. Turn it
clockwise until you feel a strong
resistance.
Note: Do not add oil further than the
maximum mark. Oil levels above the
maximum mark may cause engine damage.
Note: Immediately soak up any oil spillage
with an absorbent cloth.
INTELLIGENT OIL LIFE MONITOR
Under certain conditions the vehicle’s
intelligent oil life monitor may determine your
oil requires replacement prior to your general
service. Should this occur it is recommended
you replace your oil within two weeks or
500 mi (800 km) of being alerted.
Your authorized dealer will be able to advise
you whether only an engine oil and filter
change is recommended or whether you
should complete your general service
inclusive of oil and oil Filter.
RESETTING THE INTELLIGENT OIL LIFE
MONITOR
1. From the settings menu, press Vehicle
Settings.
2. Press Oil Life.
3. Press and hold the OK button until the
system reset confirmation appears.
ENGINE OIL CAPACITY AND
SPECIFICATION - 2.0L, FULL HYBRID
ELECTRIC VEHICLE (FHEV)
Use oil that meets the defined specification
and viscosity grade.
If you do not use oil that meets the defined
specification and viscosity grade, it could
result in:
• Component damage that your vehicle
warranty does not cover.
• Longer engine cranking periods.
• Increased emission levels.
• Reduced vehicle performance.
• Reduced fuel economy.
387
Nautilus (CFG) Canada/Mexico/United States of America, enUSA, Edition date: 202405, DOM
Maintenance
To Next Page
Loading...
