12. Turn the wrench clockwise to raise the
vehicle until the flat tire is completely
off the ground.
13. Remove the lug nuts with the lug
wrench.
14. Replace the flat tire with the spare tire,
making sure the valve stem is facing
outward. Reinstall the lug nuts until the
wheel is snug against the hub. Do not
fully tighten the lug nuts until the wheel
has been lowered.
15. Lower the wheel by turning the jack
handle counterclockwise.
16. Remove the jack and fully tighten the
lug nuts in the order shown.
17. Stow the flat tire, jack, wrench back to
spare tire compartment.
18. Remove the wheel blocks and retrieve
the warning triangle.
Stowing the flat tire
You cannot store the full-sized road wheel
in the temporary spare tire well.
1. Find the flat tire retainer strap located
under the load floor near the warning
triangle. Lower the carpeted load floor.
2. Stow the flat tire in the cargo area on the
load floor with the wheel facing up.
Secure the flat tire with the retainer strap
by following the next steps.
3. Locate the rear left side and right side
cargo tie-down rings. Push the loop end
of the retainer strap through one cargo
tie-down ring. Thread the non-loop end
through the loop.
457
Nautilus (CFG) Canada/Mexico/United States of America, enUSA, Edition date: 202405, DOM
Changing a Road Wheel (If Equipped)
To Next Page
Loading...
