Tips:
• Do not set a code that uses five of the same number.
• Do not use five numbers in sequential order.
• The factory-set code will work even if you have set your own personal
code.
Programming Memory to a Personal Entry Code
To program a personal entry code to recall a driver memory setting,
repeat Steps 1–4 above.
• Pressing 1•2 on the keypad in Step 4 will program the code to driver
memory setting 1.
• Pressing 3•4 in Step 4 will program the code to driver memory
setting 2.
Note: Pressing 5•6, 7•8,or9•0 keypad numbers in Step 4 will not
program the code to recall a driver memory setting.
Note: The factory-set code cannot be associated with a memory setting.
Erasing a Personal Code
1. Enter the factory-set 5-digit code.
2. Press and release the 1•2 on the keypad within five seconds.
The doors will lock and then unlock to confirm that the system is in
programming mode.
3. Press and hold the 1•2 for two seconds. You must do this within five
seconds of completing Step 2.
All personal codes are now erased and only the factory-set 5-digit code
will work.
78 Locks
2014 Navigator (nav)
Owners Guide gf, 1st Printing, June 2013
USA (fus)
To Next Page
Loading...
