2018 NAVIGATOR
54
1 Lighting Control
Switches on the headlamps.
Switches the headlamps off.
Switches on the position lamps,
instrument panel lamps, license plate
lamps and tail lamps.
Autolamps: Turns the headlamps on
and off based on the available daylight.
2 Front Fog Lamps
Press to switch the fog lamps on or off. You can
switch the fog lamps on when the lighting control
is in any position except off and the high beams
are not on.
3 Power-Adjustable Foot Pedals*
Your power-adjustable pedal control, on the left
of your steering column, allows you to move your
brake and accelerator pedals.
Press the ⊳ arrow to move the pedals away from
you or the ⊲ arrow to move the pedals closer
to you.
Note: Adjust the pedals only after you stop the
vehicle and place the transmission in park (P).
4 Tilt and Telescoping Steering Column
Use the control on the left side of the steering
column to adjust the position. The column
automatically moves to the full up position when
you switch the ignition off. It returns to the
previous position when you switch the ignition
on. You can switch this feature off in the
information display.
For more details about your information display
functions, please see your Owner’s Manual.
5 Autowipers
Use the rotary control to adjust the sensitivity of
the autowipers. The autowiper system turns the
wipers on only when moisture is present on the
windshield. A low sensitivity means the wipers
turn on when the system detects a large amount
of moisture on the windshield. A high sensitivity
means the wipers turn on when the rain sensor
detects a small amount of moisture on
the windshield.
Autowipers default to on and remain on until you
switch them off in the information display.
Note: Make sure that you switch off this feature
before entering a car wash.
6 Keyless Starting
Allows you to start your vehicle by pressing the
START STOP button when fully pressing down
on the brake pedal. If you leave your vehicle
idling for an extended period of time, it
automatically shuts down. Before the engine
shuts down, a message appears in the
information display, allowing the driver to
override the shutdown feature. Press the
button again to switch the engine off.
Note: Your transmitter must be inside the vehicle for
the ignition to start. The keyless warning alert sounds
the horn twice when you exit the vehicle with the
transmitter and the vehicle is in the on mode.
Instrument Panel
*if equipped
To Next Page
Loading...
