Lincoln NAVIGATOR - Comfort

2016 NAVIGATOR
18 19
PowerFold® Third-Row Seat*
The 60/40 split-folding bench seat uses a power-activated seatback release.
The three-button system allows you to fold both sides down at once, or fold
each side down independently for more flexibility. The controls are on the
right-hand rear quarter trim panel, accessible from the liftgate area.
Note: Before you fold your seats down, make sure that you place your vehicle
in park (P), open the liftgate, unfasten all safety belts and fold all head
restraints down.
To use:
1. Press the corresponding control(s) or use the middle control to fold both
seats down.
2. To return the seatback(s) to the original position(s), press the
corresponding control(s) again.
See the Seats chapter in your Owner's Manual for more information.
Note: The power-folding seats operate for 10 minutes after you switch
the ignition off.
E-Z Entry into the Third-Row Seats*
The feature allows for easier entry and exit to and from the
third-row seats.
To enter the third-row seating area:
1. Fold the head restraint forward.
2. Pull up on Lever 1.
3. Fold down the second-row seat and release the handle.
4. Pull the handle up again until the seat releases from
the oor.
5. Push the seat upward and fold it away from the third row.
To return the seat to an upright seating position:
1. Push the seat down and latch it to the oor.
2. Bring the seatback to an upright position. It should lock
into position.
3. Lift up on the head restraint until it locks into its
original position.
*if equipped
To program position 1, switch the ignition on. Move the memory features to your
preferred position. Press and hold the 1 button until you hear a tone. Use
this same procedure to set the second position by using the 2 button . You
can now use these controls to recall the set memory positions.
You can also program your memory seats to your transmitter. That way, when
you unlock your door with the transmitter, your memory features automatically
move into your saved position. See the Seats chapter in your Owner's Manual
for more details.
Moonroof*
You can open or close the sliding
shade manually after you close the
moonroof. Pull the shade toward the
front of the vehicle to close it. The
moonroof control is on the overhead
console. To open, press and release
the SLIDE control. The moonroof stops
short of the fully opened position. To
fully open the moonroof, press and
release the SLIDE control again. To close, pull and release the SLIDE control.
Press and release the TILT control to vent the moonroof. Pull and hold the TILT
control to close the moonroof.
Comfort
Front Climate Controlled Seats*
To use the heated seats, press the right side of the button . For cooled seats,
press the left side of the button . Press the desired button repeatedly to cycle
through the settings, from the highest to the lowest, and then off. More indicator
lights mean higher settings.
Second-Row Controls*
Located on the rear of the center console, auxiliary climate and heated seat
controls let second-row passengers make adjustments and power smaller
accessories independently from the front-row controls.
Memory Seat Feature
The memory function saves and recalls the positions of the driver seat, power
mirrors, adjustable pedals and steering column. Use the control located on the side
of the driver’s seat to program and then recall saved memory positions.
*if equipped
Lever 1
Position 2
Position 3