Table of Content
Page 7
Service Training
RP01 / Chapter 1
115 804 2401.0304
09.06
7.9 Reach cylinder re-fitting 16
7.9.1 Reach cylinder 16
7.9.2 Reach cylinder dismantling 17
7.9.3 Reach cylinder reassembly 17
7.10 Tilt and lift cylinder hoses 18
8 Mast unit and attachments 1
8.1 Introduction 1
8.2 Forks removal 2
8.2.1 Forks refitting 3
8.2.2 Forks inspection 3
8.2.3 Fork latches 3
8.3 Mast unit removal 4
8.4 Mast unit refitting 7
8.5 Mast unit dismantling 9
8.5.1 Mast unit reassembly 09.03 10
8.6 Mast roller sizing 09.03 10
8.6.1 Mast roller shimming 09.03 11
8.7 Mast rubbing pads 09.03 12
8.8 Primary lift jack removal 09.03 13
8.8.1 Primary lift jack replacement 09.03 15
8.9 Secondary lift jack removal 09.03 16
8.9.1 Secondary lift jack refitting 09.03 18
8.10 Primary and secondary lift jack dismantling 09.03 20
8.10.1 Primary and secondary lift jack reassembly 09.03 21
8.11 Lift jack bleeding 09.03 22
8.12 Chains 03.04 23
8.12.1 Chain inspection 03.04 24
8.12.2 Chain service life 03.04 24
8.12.3 Chain replacement and shortening 03.04 24
8.13 Chain adjustment 09.03 25
8.13.1 Chain associated equipment check 09.03 25
8.13.2 Mast chain adjustment 09.03 25
8.13.3 Carriage chain adjustment 09.03 26
8.14 Tilting sideshift assembly (187 mast) 09.03 27
8.14.1 Tilting sideshift unit removal (187 mast) 09.03 28
To Next Page
Loading...
