Line 6 POD HD300 User Manual

Setup Details
1•3
Footswitch Mode
We’ve offered two types of behaviors for how the MODE footswitch accesses the “Preset,”
“Pedal” and “Looper” footswitch modes. (Please also see your POD HD Pilot’s Guide for
more about the MODE footswitch.)
• Normal: Sets the “Normal” behavior, where each click of the MODE footswitch
incrementally selects one of the three modes: Preset Mode (green LED), Pedal Mode
(amber LED) and Looper Mode (red LED).
• Hold4Lpr: Sets an alternative “Hold for Looper” behavior, where clicking the
MODE footswitch incrementally selects between only the Preset or Pedal Footswitch
Modes. To enter Looper Mode, press and hold the MODE footswitch. To exit Looper
Mode, simply click MODE again.
AC Rate
All POD HD Amp Models include simulation of AC hum typical of the AC Vacuum Tube
Heater component, which is an important part of the tonality of a tube amplifier. Set the
AC Rate to match that of the USA (60 Hz) or UK (50 Hz) frequency for authenticity.
Note: This setting may be subtle depending on the current Amp Model settings and more
apparent when synchronizing this setting with the AC rate of any tube amplifier that POD
HD is plugged into.

Line 6 POD HD300 Specifications

General

Amp Models	16 HD amp models
Display	LCD
Type	Multi-Effects Processor
Number of Models	16 amp models
Computer Connectivity	USB
Footswitches	4
USB	Yes
Power Supply	Included
Effects Types	Distortion, modulation, delay, reverb
Presets	128
Cabinet Models	16 cab models
Expression Pedal	Built-in expression pedal
Effects	80+ M-class effects